Blower motor resistor and blower motor – replacement
Warning: The models covered by this manual are equipped with a Supplemental Restraint System (SRS), more commonly known as airbags. Always disarm the airbag system before working in the vicinity of any airbag system component to avoid the possibility of accidental deployment of the airbag, which could cause personal injury (see Chassis electrical system). Do not use a memory saving device to preserve the PCM’s memory when working on or near airbag system components.
Blower motor resistor
1. Disconnect the cable (s) from the negative battery terminal(s) (see Engine electrical systems).
2. Disconnect the electrical connector from the blower motor resistor (see illustration).
10.2 Blower motor resistor (A) and mounting bolts (B)
3. Remove the blower motor resistor mounting screws and remove it from the blower housing.
4. Installation is the reverse of removal.
Blower motor
5. Disconnect the cable (s) from the negative battery terminal(s) (see Engine electrical systems).
6. Disconnect the electrical connector from the blower motor, then remove the mounting screws and lower the blower motor out of the housing (see illustration 10.2).
7. Installation is the reverse of removal.